







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Midway City, CA: What the Job Actually Costs
Cabinets & countertops in Midway City usually run $14,000 – $45,000 for a full replacement, with most 1950s – 60s tract kitchens landing in the $18,000 – $28,000 range. Cabinet installation alone runs $4,000 – $13,000 and countertop installation $2,000 – $6,500. Plan on three to four weeks from demo to final caulk, with a 4 – 6 week lead time before that while cabinets are built. Call (833) 522-5059 for a free on-site estimate.
Old Cabinets in Old Houses: How the Job Actually Runs

Most of the kitchens we open up in Midway City were installed when the house was new, and the house was new in the 1950s or 60s. That means we’re rarely working on flat walls, square corners, or plumbing that lines up with anything. Here’s the sequence.
Stage 1: Measure and check the bones (day 1)
We template the room properly, which means checking wall plumb and floor level at multiple points, not just running a tape along the counter line. In Midway City’s post-WWII stock, we typically find walls out of plumb by a half inch or more and floors that have settled unevenly. You decide the cabinet line and door style now, because that decision sets the ordering lead time.
Stage 2: Order and finalize the layout (weeks 1 – 5)
Cabinets get ordered once the layout is locked. You’ll also pick the countertop material here, because stone has to be templated after the cabinets are in, not before. Decide appliance sizes now too. A 30-inch range sliding into a 30-inch opening is fine on paper and a nightmare in a 60-year-old alcove that measures 29 5/8. Nothing gets ordered until those numbers are settled.
Stage 3: Demo and prep (days 1 – 2 of install)
Old cabinets and counters come out, along with the backsplash if it’s going. We inspect what’s behind them: water damage around the sink, old galvanized or early copper supply lines, and drywall that’s often gypsum board or plaster on the older homes. If the wall behind the range needs repair or the shutoff valves are seized, that’s flagged before anything new goes in.
Stage 4: Set cabinets and template the counter (days 3 – 5)
Boxes get hung level and shimmed to the actual wall, not to a theoretical straight line. Crown and fillers cover the gaps the old plaster creates. Then the countertop fabricator templates on site, and the slab goes out for cutting. That template-to-install gap runs 5 to 10 business days depending on material.
Stage 5: Counter install, sink, and finish (days 10 – 15)
The slab goes down, the undermount sink gets set with the right clips, the faucet and disposal go in, and the final caulk line closes it out. You walk the job with us before we call it done. Anything that isn’t right gets fixed under our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Matter: Cabinet Boxes, Doors, and Slabs
Here’s what you’re really deciding between, and what each one does to the budget.
- Stock vs. semi-custom cabinets. Stock boxes are fast and cheap but come in fixed sizes, which means filler strips in a room that isn’t square. Semi-custom (KraftMaid is the line we use most) costs more and lets you fit the actual wall. In a Midway City kitchen with uneven walls, semi-custom usually saves you from visible gaps.
- Plywood vs. particleboard boxes. Plywood holds up better around the sink where moisture lives. Particleboard is fine for upper cabinets away from water. It’s the single biggest quality difference people miss when comparing quotes.
- Painted MDF vs. solid wood doors. Painted MDF gives you a clean shaker look at a lower price. Solid wood handles dings and refinishing better over decades. Both are fine; pick based on how long you plan to stay.
- Quartz vs. granite vs. laminate. Quartz is the default for most Midway City kitchens: non-porous, no sealing, and consistent slabs. Granite costs similar and handles heat better but needs sealing. Laminate is the budget play at roughly a third the cost and holds up reasonably in a rental or a flip.
- Sink and faucet grade. An undermount stainless sink with a solid brass faucet (Grohe makes a durable one) costs more up front and lasts. Builder-grade faucets are the first thing to fail in a kitchen.
What Cabinets & Countertops Cost in Midway City, CA

The full range is $14,000 – $45,000. Here’s where that number actually breaks down.
| Line item | Typical range |
|---|---|
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash (if included) | $800 – $2,500 |
| Full kitchen scope | $14,000 – $45,000 |
Five things push a job from the low end to the high end:
- Linear footage and layout. A 10-foot galley costs a fraction of a 20-foot L with an island.
- Condition behind the cabinets. Water damage, failed shutoffs, or a wall that needs reframing adds real money.
- Moving plumbing or electrical. Relocating a sink or adding circuits for a new range means permits and trade work.
- Material grade. Semi-custom cabinets and quartz at the high end vs. stock and laminate at the low end is a $10,000 swing by itself.
- Permit scope. Cabinets and counter swaps often don’t need one; anything touching plumbing, electrical, or structure does.
Every written estimate breaks these out line by line. What’s included: demo, haul-away, install labor, and finish carpentry. What’s typically not: appliance cost, major plumbing or electrical rework, and drywall repair beyond small patches. We put all of that in writing before anyone swings a hammer.
See the difference
Before
After
Before
After
Before
AfterWhy Midway City Kitchens Are Their Own Animal
Midway City is one of the last unincorporated islands in Orange County, and that changes the paperwork. Permits run through OC Public Works, not a city building department, and plans get checked on the county’s timeline. Contractors who only know city processes routinely misjudge how long that takes, and homeowners end up with cabinets sitting in the garage for weeks. We build that county review time into the schedule from day one.
The housing stock matters just as much. The 92655 blocks are dominated by small post-WWII single-story tract homes from the 1950s and 60s, mixed with manufactured homes. These kitchens were built small and built cheap, and the wall cabinets are usually 30 inches tall set against a soffit. Pulling that soffit to gain height is often the single best move in the room, but it’s a structural question, not a cosmetic one. We see it on nearly every job in the neighborhood.
Lot lines here are famously tight and irregular on the old unincorporated parcels, which matters if your cabinet job is part of a bigger scope. Homeowners often pair this with a Garage Conversion ADU in Midway City or a New Detached ADU in Midway City, and county setback review on those parcels is where projects snag. Our Kitchen Remodeling in Midway City page covers the wider scope if you’re going beyond cabinets and counters.
Serving Midway City, CA – Our Local Coverage Area
We serve Midway City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Cabinets & Countertops in Midway City

Three to four weeks from demo to completion, with a 4 – 6 week cabinet lead time before that starts. Stone countertops add 5 – 10 business days between template and install. Call (833) 522-5059 for a schedule specific to your kitchen.
Usually no, unless you’re moving plumbing, electrical, or structure. A straight swap of cabinets and counters doesn’t trigger a permit; relocating a sink or adding a circuit does, and that runs through OC Public Works. We tell you which side of that line your job falls on before you sign anything.
Yes, and it’s the most common way we do it. The sink stays where it is, the supply and drain lines stay put, and the new cabinet gets cut to match. It saves money and schedule. If you’re considering a sink relocation, that decision belongs in the planning stage, not mid-install.
Most jobs land between $14,000 and $45,000 depending on size, material, and what’s behind the old cabinets. Cabinet installation alone runs $4,000 – $13,000; countertops $2,000 – $6,500. Call (833) 522-5059 for an exact quote, estimates are free.
Every cabinets and countertops job is covered by our 730-Day Done Right Promise. If something isn’t right, we make it right. That covers workmanship; manufacturer warranties on the cabinets and slabs run separately, and we walk you through both.
Get a Free Estimate on Cabinets & Countertops in Midway City
Call (833) 522-5059 and a live person picks up, any hour. We’ll schedule a free on-site estimate, measure the actual kitchen, and hand you a written line-item quote with fixed pricing and no change orders. If you’re weighing cabinets and countertops as part of our kitchen remodeling service, we’ll scope both together. We cover all of Midway City and the surrounding area.
Written by the team at Groundwork Construction Co.












