







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
What a Chain Link Fence in North Tustin, CA Costs and How Long It Takes
A chain link fence in North Tustin typically runs $3,500 to $9,000, and most residential runs are finished in two to four working days once materials land on site. Chain Link Fence work here breaks into three decisions: layout and grade, gauge and coating, and gate hardware. Because so many lots sit on a slope, the timeline hinges on how much terrain the fence has to follow. Call (833) 522-5059 and we’ll walk your property line, measure it, and put a fixed number in writing.
How a Chain Link Fence Goes In, Stage by Stage

Every job follows the same sequence. What changes is how long each stage takes, and that’s usually driven by slope and soil, not by the fence itself.
Stage 1: Walk the line and confirm the layout (day 1, 1 – 2 hours)
We meet you on site and mark the actual property corners against your plat or a survey. This is where you decide gate placement, whether the run hugs an existing retaining wall or sits back from it, and whether you’re fencing to the edge of a hillside or stopping short of the drop. On the larger lots in North Tustin, corners are often more than a hundred feet apart, so getting this right up front saves excavation later.
Stage 2: Utility locate and excavation (day 1, half a day)
Before a single post goes in, the 811 locate gets called and marked. That matters on these properties because irrigation lines, pool equipment feeds, and detached-garage electrical commonly cross the fence path. Once lines are flagged, we auger post holes to depth and set terminal posts in concrete. Slope changes how deep we go and how many intermediate posts we need to hold the top rail at a consistent height.
Stage 3: Set posts and let concrete cure (day 1 into day 2)
Terminal, corner, and gate posts get concrete and cure overnight. This is the one stage you can’t rush. Line posts follow the string line, and on a hillside lot that means racking the fabric later rather than trying to bend rail. You don’t have to make any decisions during this window, which is a good time to confirm gate swing direction with us if you haven’t.
Stage 4: Stretch fabric and hang gates (day 2 into day 3, 3 – 6 hours)
Top rail and tension bands go on, the fabric is pulled with a stretcher bar, and the bottom is tied off. Gates get hung and adjusted so they latch without dragging, which takes the longest on sloped ground where a swing gate can’t self-close against gravity. If you picked a self-closing or keyed-latch gate, this is when we fit the hardware.
Stage 5: Final walk and cleanup (end of day 3)
We walk the whole run with you, check tension, gate alignment, and post plumb, and haul off spoil and packaging. Any adjustments happen now, not later. That walk is also when you sign off on the work under our 730-Day Done Right Promise, so if anything isn’t right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Chain Link Fence Options and the Trade-Offs That Matter
Chain link isn’t one product. The choices you make here decide whether the fence lasts fifteen years or thirty, and how it looks next to a custom home.
- Gauge of wire. Residential fabric usually comes in 11.5-gauge and 9-gauge. The heavier 9-gauge costs more per linear foot but resists a dog pushing through and holds tension longer. On estate lots with horses or large dogs, 9-gauge is the honest choice.
- Coating: galvanized vs. vinyl-clad. Plain galvanized is the budget option and weathers to a dull gray. Vinyl-clad (black or green) costs more but blends with hillside vegetation and reads as intentional rather than temporary. For homes where the fence is visible from the street or a patio, the clad version earns its price.
- Post and rail spec. Standard is 2⅜-inch line posts with a 1⅝-inch top rail. Heavier 2⅜-inch top rail and thicker wall posts make sense on long unsupported runs and in Santa Ana wind corridors, where a light fence will rattle and eventually sag.
- Height. Four feet is the residential default; five and six feet cost more in fabric and taller posts but help with privacy and pet containment. Check any HOA or CC&R limits before you commit to six feet.
- Gates and hardware. Walk gates, double drive gates, and self-closing or keyed latches each add cost. A wide drive gate needs heavier framing and a proper drop rod to keep from sagging.
- Brand. Master Halco and Ameristar are the two fabric and post lines we specify most, because they’re consistent in gauge and coating and hold up on slope. You’ll see the exact spec itemized on your estimate.
What a Chain Link Fence Costs in North Tustin, CA

The lead range is $3,500 to $9,000 for a typical residential run. Where you land depends on five variables:
- Linear footage. A small backyard enclosure sits near the low end; fencing a half-acre-plus perimeter pushes toward the top.
- Slope and terrain. Hillside lots require more posts, racked fabric, and sometimes a short retaining or stepped section, which adds labor.
- Site access. Long driveways and gated entries change how equipment and materials reach the line, and that’s time.
- Material grade. The jump from galvanized 11.5-gauge to vinyl-clad 9-gauge with heavier rail is the single biggest swing in the estimate.
- Gates. One walk gate is minor; a wide drive gate with heavier framing and hardware can add a meaningful share of the total.
Your written estimate itemizes footage, post spacing, gauge, coating, gate count, and concrete, so the number you see is the number you pay. What it typically excludes: utility relocation if a line sits directly in the fence path, and any grading or retaining work a slope demands beyond standard post-setting. Those get quoted separately before anyone digs. Pair this with a driveway refresh and it’s a natural time to look at Fence Installation in North Tustin as a full perimeter plan.
See the difference
Before
After
Before
After
Before
AfterWhat North Tustin Homes Specifically Do to This Job
North Tustin is an unincorporated enclave, and that shapes a chain link job here in ways that surprise people. Because the county permits the work rather than a city hall, the approval path runs through OC Planning and Building, not a city counter, and fence permits and setbacks get reviewed under county rules. Large custom homes on hillside lots mean the fence line often follows a slope, so post spacing, racked fabric, and gate swing all have to answer to grade. On the ridge roads, grading and slope issues mean a run along a retaining wall or grade break needs more care than a flat backyard. The inland foothill climate matters too: hot dry summers and Santa Ana wind events put load on long unsupported runs, and wildfire exposure along the canyons makes a defensible-space-clear perimeter more than a cosmetic concern. We regularly see older galvanized runs on these properties sagging at the corners where posts were set shallow on slope. Homeowners often pair a new perimeter with ADU Site Prep & Utilities in North Tustin when a detached structure is going in.
Serving North Tustin, CA – Our Local Coverage Area
We serve North Tustin and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Chain Link Fence in North Tustin

Most residential runs are done in two to four working days once materials are on site. Slope, gate count, and utility locates are the usual reasons a job stretches past that, and we give you a firm window in writing before we start.
Fence permits in North Tustin go through OC Planning and Building because the area is unincorporated. Whether your specific run needs one depends on height and location, and we confirm that during the walk-through and handle the submittal so you’re not chasing the county yourself.
Yes, in the vast majority of cases the fence goes in with the plumbing, pool equipment, and existing structures untouched. A utility locate happens before excavation, and if a line sits directly in the fence path we reroute around it, or quote the relocation separately so there are no surprises.
The range is $3,500 to $9,000, with footage, slope, gauge and coating, gates, and site access driving where your job lands. Call (833) 522-5059 for an exact quote, and estimates are free.
Every Chain Link Fence we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That covers workmanship, and the manufacturer’s warranty covers the fabric, posts, and hardware.
Get a Free Chain Link Fence Estimate in North Tustin
Call (833) 522-5059 for a free on-site estimate on your Chain Link Fence in North Tustin. We’ll measure the line, check the slope and any HOA or county height limits, and hand you a written itemized quote with footage, gauge, gates, and concrete spelled out. If the run is part of a bigger plan, our fence installation service covers the full scope, and you’ll also find us across North Tustin. A real person answers the phone, day or night. Homeowners often pair this with Door Installation in North Tustin while we’re on site.
Written by the team at Groundwork Construction Co.












