







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Stanton, CA: What It Takes
Asphalt paving in Stanton usually runs $3,500 – $9,000 for a new drive, and resurfacing an existing one with an overlay typically lands in the lower half of that range. Most residential drives here are done in two to four days: tear-out and base prep on day one, asphalt laid the next day, then a short cure before you park on it. Call (833) 522-5059 to set up a free on-site estimate.
How the work actually goes, stage by stage

We don’t hand you a start date and disappear. Here’s the real sequence so you know what’s happening in your driveway and what you’ll be asked to decide along the way.
1. On-site measure and base assessment (day of the estimate)
We measure the square footage, check the slope away from the house, and probe the existing base. A drive that’s holding shape can often take an overlay; one that’s cracked through and sunk in spots needs the base rebuilt. That call is the difference between a resurface and a full replacement, so we make it in front of you, not later.
2. Teardown and haul-off (one day for most Stanton drives)
If we’re replacing, we break out the old surface and haul it away. If we’re resurfacing, we grind the top and clear the debris. A typical Stanton driveway is small, often 400 to 700 square feet, so this usually finishes in a day. You’ll pull your cars out before we start, and we’ll tell you when the street needs to stay clear.
3. Base repair and grading (same day or next)
This is where a long-lasting drive is won or lost. We recompact the base, add class 2 aggregate where it’s thin, and set the grade so water runs off toward the street and away from your foundation. On the older lots in Stanton, we’re often correcting what a previous crew let settle.
4. Laying asphalt (one day)
Hot-mix goes down at the right depth and gets rolled while it’s still workable. Your decision here is thickness: 2 inches is the standard residential top coat, and a heavier lift makes sense on a drive that takes regular truck traffic. You approve the spec before we start.
5. Cure and walkthrough (one to two days before parking)
Fresh asphalt needs time to harden. Plan to keep cars off for at least a day, longer in cool weather. We walk the finished drive with you, check the edges and grade, and leave you with the job in writing under our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices you’ll make before we lay it
Resurfacing and new asphalt aren’t one product. The decisions below are the ones that change both the number and how the drive looks and lasts.
- Resurface vs. full replacement. An overlay is cheaper and faster when the base is sound. If the base is failing, an overlay just delays the same cracks, and we’ll say so.
- Asphalt thickness. Two inches is standard; a heavier lift costs more but holds up better on a drive that sees a work truck or trailer.
- Edging and borders. A concrete curb or edge lock keeps the asphalt from raveling at the sides. Worth it on a drive that gets sun-baked every summer.
- Seal coat timing. A fresh seal extends life and evens out color, but it goes on after the asphalt cures, not the same week.
- Drainage and grade. Where the water goes is a design choice, not an afterthought. We set it so the occasional heavy winter rain runs to the street.
What Asphalt Driveways & Resurfacing costs in Stanton, CA

Plan on $3,500 – $9,000 for asphalt paving on a typical Stanton residential drive. Resurfacing an existing drive is usually less than a full replacement because the base stays in place. Every estimate we give is line-itemed and upfront, so the number you see is the number you pay.
Four things move that number:
- Square footage. A short 15-foot-wide drive is one budget; a wide double drive is another.
- Existing condition. Cracked, sunken base means removal and rebuild, which adds cost.
- Access. Tight lots and close neighbors, common in Stanton, can slow haul-off and add labor.
- Thickness and edging. Heavier asphalt and border work push toward the high end.
Your written estimate will spell out removal, base prep, asphalt, edging, and cleanup. Sealing is usually quoted as a separate, later step so you know it’s coming.
See the difference
Before
After
Before
After
Before
AfterWhat Stanton homes specifically do to this job
Stanton is landlocked and nearly built out at about 3 square miles, so we’re almost never working a fresh lot. We’re working a 1950s to 1970s tract home or a manufactured-home park where the drive has seen decades of sun and traffic. That means we spend real time on the base and on drainage, because the sun bakes these drives and the occasional hard winter rain finds every low spot. Tight lots and parking on a narrow street slow the haul-off, and we plan for it. Most of our Stanton work clusters around the older tracts and mobile-home communities near Beach Boulevard and along the residential grid off Cerritos Avenue.
Where the wider scope comes up, a new drive is often part of a Driveway & Pavers in Stanton project, and homeowners often pair resurfacing with a Chain Link Fence in Stanton or site work tied to an ADU Site Prep & Utilities in Stanton build. If you’re mapping the whole front yard, our Driveway & Pavers service covers the rest, and you can see everything we do across Stanton on the service-area page.
Serving Stanton, CA – Our Local Coverage Area
We serve Stanton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Asphalt Driveways & Resurfacing in Stanton

Most residential asphalt driveways here take two to four days from tear-out to final walkthrough, plus a short cure before you park on it. Tight lots and weather can add a day. Call (833) 522-5059 for a timeline for your specific drive.
Resurfacing an existing drive usually doesn’t need a permit, but new paving that touches the street apron or changes grade may require one through the city. We check what your job needs before we start. Call (833) 522-5059 and we’ll sort the paperwork.
Yes, when the base is sound. An overlay goes right over a stable surface and saves time and money. If the base is cracked or sunken, we’ll recommend a rebuild instead. Call (833) 522-5059 and we’ll tell you which one your drive needs.
Expect $3,500 – $9,000 for a typical Stanton drive, with resurfacing usually toward the lower end. Access, base condition, and thickness move the number. Call (833) 522-5059 for a free, line-itemed estimate.
Every asphalt job we do is backed by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction. Call (833) 522-5059 to get started.
Get a free estimate for your Stanton driveway
Call (833) 522-5059 to set up a free on-site estimate. We’ll come out, measure, check the base, and hand you a line-itemed price with no surprises. A live person answers, day or night, and you’ll know within the visit whether your driveway needs a resurface or a rebuild. Financing is available if you need it.
Written by the team at Groundwork Construction Co.












