







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Fountain Valley, CA: What It Costs and How Long It Takes
A chain link fence in Fountain Valley typically runs $3,500 to $9,000 for a standard residential lot, and most jobs are finished in two to four working days once materials are on site. That range covers removal of the old fence, new posts set in concrete, and either galvanized or vinyl-coated mesh. The number moves mostly with linear footage, height, gate count, and how much old fencing has to come out. Call (833) 522-5059 and we’ll walk your property line and give you a written, line-item estimate.
How We Build a Chain Link Fence Here, Start to Finish

Every job follows the same five stages. Here’s what each one looks like and what you’ll be deciding along the way.
Stage 1: Walk the line and confirm the layout (day 1, about an hour)
We start by walking the property line with you and confirming exactly where the fence runs. On a standard Fountain Valley lot that’s usually the back line and one or both sides. You’ll decide at this point whether the fence sits on the property line or a few inches inside it, and we’ll note any shared-line neighbors who need to be looped in before posts go in.
Stage 2: Demo and locate utilities (day 1, two to four hours)
Out comes the old fence, posts and all. If there’s an existing chain link, we pull the mesh, cut the posts at grade, and haul the concrete footings. Before anything gets dug, we call for utility locating. This matters more than people expect on these older ranch lots, where irrigation lines, gas stubs, and old patio electrical were often run close to the rear property line without much documentation.
Stage 3: Set posts in concrete (day 1 into day 2)
Posts go in on 8-foot spacing, set in concrete footings with Quikrete or Sakrete fast-set mix. Terminal posts at corners and gate openings get larger footings because they carry the tension of the whole run. The concrete needs to cure before you load the fence, so posts set on day one usually get their mesh the next day. That’s a real scheduling constraint, not a shortcut.
Stage 4: Hang mesh, rails, and gates (day 2 or 3)
Top rail, tension wire, mesh, and gates go on once the footings have set. This is where a fence either feels solid or feels like a loose clothesline. We tension the mesh properly and adjust gate hardware so it swings clean and latches without lifting. You’ll choose gate placement and swing direction here if you haven’t already.
Stage 5: Walkthrough and cleanup (final day)
We walk the finished fence with you, check every post, gate, and tie, and haul off all scrap and leftover concrete bags. If your job sits inside a full Fence Installation in Fountain Valley, the chain link usually goes in alongside the other runs so the whole property is finished in one pass. Our fence installation service covers the wider scope if you’re deciding between fence types.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Chain link isn’t one product. Most of the decisions come down to four choices, and each has an honest trade-off.
- Galvanized vs. vinyl-coated mesh. Galvanized steel is the standard and the least expensive. Vinyl-coated (black or green) runs roughly 15 – 25% more and reads much less industrial against a landscaped yard. On a mid-century ranch home in Fountain Valley, black-coated chain link tends to disappear into the planting where bare galvanized stands out.
- Height. Four-foot is the residential standard. Five-foot adds privacy and keeps larger dogs in. Six-foot costs more and, in many parts of the city, may require a permit depending on HOA rules and lot lines, so we confirm that before ordering.
- Gauge and mesh size. Heavier-gauge wire and a smaller mesh take longer to sag and dent. If you have kids, dogs, or a corner that takes wind off the Santa Ana events, it’s worth the upgrade.
- Gates. Walk gates and drive gates are priced separately and rarely include the automated opener. We quote gate count and width up front so there’s no surprise on the final number.
What Chain Link Fence Costs in Fountain Valley, CA

For a typical single-family lot in Fountain Valley, a chain link fence runs $3,500 to $9,000. That’s the honest market range for the city. Here’s what pushes a job toward one end or the other:
- Linear footage and lot layout. A standard rear and two-side run on a typical suburban lot lands in the middle of the range. A full perimeter with extra corners moves to the high end.
- Removal of existing fence. Demo and haul-off of old posts and concrete adds cost, especially if the old footings are deep or the fence runs through established landscaping that has to be protected.
- Material grade. Coated mesh, heavier gauge, and larger terminal footings all add. Galvanized standard mesh is the least expensive path.
- Gate count. Each gate is priced separately. Multiple gates or wide drive gates push the number up.
- Site access and terrain. Sloped backyards, tight side-yard access, or a fence line that has to weave around existing trees or a shed all add labor.
Written estimates include the demo, footings, mesh, posts, top rail, tension wire, gates, and cleanup. What’s typically not in a chain link bid: automated gate openers, landscaping repair or replacement along the fence line, and any permit fees if a height or lot-line condition triggers one. We itemize every line so you see exactly what’s included before work starts, and the number on the written estimate is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Fountain Valley Homes Specifically Do to This Job
Fountain Valley is a fully built-out mid-century suburb, incorporated in 1957, with almost no vacant parcels left. Nearly every chain link job we run here is a replacement on a 1950s – 1970s single-story ranch, not a new install on fresh ground. That changes the work in ways a newer inland city wouldn’t see. The old fence almost always has footings set decades ago, often in soil that’s seen a lot of irrigation, and sometimes the rear line was quietly moved by a prior owner when a patio cover or shed went in. Unpermitted patio enclosures and old garage conversions routinely surface during a fence replacement because the fence line runs right up against them.
The other reality is permitting. With no undeveloped land, Fountain Valley runs a tight code enforcement operation, and even a fence replacement can trigger a plan check if the height, lot-line placement, or an existing condition raises a flag. We pull what’s required and get it inspected. If you’re also tying the fence into a larger project, homeowners often pair this with ADU Site Prep & Utilities in Fountain Valley or Door Installation in Fountain Valley while the yard is opened up. On the coastal-influenced climate here, mild wet winters mean the short rainy season sets the schedule, and posts set in damp soil need to cure before anything loads them. We cover the whole city, ZIPs 92708 and 92728, from the homes off Talbert to the streets near Mile Square Park; see our Fountain Valley service-area page for the full coverage map.
Serving Fountain Valley, CA – Our Local Coverage Area
We serve Fountain Valley and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Fountain Valley

Most Fountain Valley chain link fence jobs are finished in two to four working days, with the concrete footings curing overnight before the mesh goes up. A standard rear-and-sides run on a typical lot is two days; a full perimeter with demo and multiple gates is closer to four. Call (833) 522-5059 for a realistic timeline on your specific lot.
It depends on height, lot-line placement, and HOA rules, and we confirm that before ordering anything. A standard four-foot residential chain link often doesn’t require a permit, but a six-foot fence or one that sits on a property line in some conditions can. We pull what’s required and handle the inspection. Call (833) 522-5059 and we’ll tell you exactly what your job needs.
A typical residential chain link fence in Fountain Valley runs $3,500 to $9,000, with the exact number driven by linear footage, height, mesh grade, gate count, and how much old fence comes out. Coated mesh and heavier gauge add to the top of the range. Call (833) 522-5059 for an exact line-item quote, and the estimate is free.
No for plumbing and structure, and rarely for electrical. Fence posts go in at the property line, well away from interior plumbing and structure, and utility locating handles the irrigation and electrical stubs that run near the rear line. Existing trees and shrubs along the line may need trimming or protection, and we plan that with you before we dig. Call (833) 522-5059 to schedule a walkthrough.
Every chain link fence we build is covered by our 730-Day Done Right Promise, which is one of the longest workmanship guarantees in residential construction. If a post works loose, a gate sags, or a run of mesh loses tension within that window, we make it right at no cost to you. Call (833) 522-5059 with any warranty question.
Get a Free Chain Link Fence Estimate in Fountain Valley
We’ll walk your property line, confirm the layout, and hand you a written, line-item estimate with no surprises on the final number. Calls are answered by a live person, so you’ll reach someone right away, not a voicemail box. Call (833) 522-5059 to schedule your free on-site estimate for a chain link fence in Fountain Valley, and we’ll tell you exactly what the job involves and what it costs.
Written by the team at Groundwork Construction Co.












