







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Santa Ana, CA: What It Really Takes
Concrete driveways and concrete work in Santa Ana typically run $4,500 – $12,000 for a full driveway pour, and the job usually takes 3 – 5 working days from demo to the day you can park on it again. The pour itself is one morning. Everything around it – demo, subgrade, forms, rebar, inspection, cure – is where the time goes. If you own one of the pre-1960 houses that make up so much of Santa Ana, one extra step often shows up before a single yard of concrete arrives: the old apron may be tied to a foundation that doesn’t meet the current standard, and that geometry has to be reconciled before the city will sign off. Call (833) 522-5059 and we’ll walk the driveway with you, free.
Day by day: how a concrete job actually moves in Santa Ana

Concrete work isn’t a single day of labor. It’s five distinct stages, and each one has a decision that belongs to you, not to us. Here’s the sequence we run on a typical Santa Ana driveway.
Stage 1 – Site walk and layout (day of estimate, 45 – 60 minutes)
We measure the actual square footage, check the slope from the garage door to the street (Santa Ana’s older lots often pitch differently than the builder intended), and probe what’s under the existing slab. On a Spanish Colonial Revival or Craftsman bungalow, that probe matters: additions that were never permitted sometimes show up as a second layer of concrete poured on top of the first. You decide the width, whether you want a widened apron for two cars, and whether any part of the job overlaps with the wider Driveway & Pavers in Santa Ana work you might be planning later.
Stage 2 – Demo and haul-away (day 1, 4 – 6 hours)
We break out the old concrete, load it, and haul it. On a 400 – 600 sq ft driveway this is a full morning with a breaker and a crew, and it’s loud. If a mature tree’s roots have pushed up a section near the curb, we cut that section out separately so we don’t damage the root ball. You decide nothing here, but you should expect to lose street parking access for the day.
Stage 3 – Subgrade, forms, and reinforcement (day 2, 5 – 7 hours)
This is the stage nobody sees and everything depends on. We compact the subgrade, build forms to the agreed slope, and set #3 or #4 rebar on chairs (or mesh, depending on load). On Santa Ana’s hot, dry fall and winter Santa Ana winds, subgrade moisture matters – a bone-dry base pulls water out of the mix before it cures and you get a weak slab. You decide here whether you want a control-joint layout that reads cleanly or a simpler grid, and whether you want a decorative finish (more on that below).
Stage 4 – Inspection and pour (day 3, 3 – 5 hours)
If the job requires a city inspection – and in Santa Ana, driveways that touch the public right-of-way usually do – the inspector signs off on forms and reinforcement before we pour. Then the truck arrives, we place, screed, float, and finish. You’ll want to be home for this part if you’re choosing a finish in person rather than from a sample.
Stage 5 – Cure, joint sealing, and the wait (days 3 – 7)
Concrete reaches usable strength in about 7 days and full design strength at 28. We keep vehicles off for at least 7 days and heavy trucks off longer. You get the control joints cut, sealed, and a written note on when to park, when to water, and when it’s safe to drive on.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete options you’ll actually choose between
Concrete is not one product. The choices below are the ones that change both the number and how the driveway looks in five years.
- Standard broom-finished concrete: The default. Rough texture, good grip in rain, hides tire marks reasonably well. Cheapest option and the right call for most Santa Ana driveways.
- Exposed aggregate: The top layer of cement is washed away to reveal the stone. More slip-resistant than broom finish, and it hides cracks better as it ages. Costs more per square foot and is harder to patch cleanly if a section ever fails.
- Stamped or decorative finishes: Patterned to look like brick or stone. Adds meaningful cost and, in a hot Santa Ana summer, a darker stamped surface gets noticeably hotter underfoot. Worth it on visible frontage; often skipped on a side or rear pad.
- Fiber-reinforced vs. rebar: Fiber mesh is cheaper and controls surface cracking; rebar carries structural load and is what we recommend under anything a vehicle parks on. On a real driveway, rebar wins.
- Quikrete or Sakrete bagged mix vs. ready-mix truck: For a small pad, walkway, or repair, bagged Quikrete or Sakrete is fine. For a full driveway, ready-mix delivered on site is the only sensible route – consistent mix, correct slump, no wheelbarrow marathon.
What Concrete Driveways & Concrete Work costs in Santa Ana, CA

Most Santa Ana concrete driveway work lands between $4,500 and $12,000. Here’s what that range covers and what moves a job toward one end or the other.
| Line item | Typical range |
|---|---|
| Concrete driveway installation | $4,500 – $12,000 |
| Driveway replacement (demo + new pour) | $5,000 – $14,000 |
| Paver driveway (for comparison) | $7,000 – $18,000 |
The five variables that push a job up or down:
- Square footage: A 400 sq ft single-car driveway sits near the bottom. A 700 sq ft double with a widened apron sits near the top.
- Existing condition: A clean slab comes out fast. A slab poured over an old one, or one with tree-root heave, adds demo time and haul-away cost.
- Subgrade and slope: Santa Ana lots with odd grading sometimes need extra base material or a mow strip to hit the required slope to the street.
- Finish: Broom finish is the baseline; exposed aggregate or stamped adds per-square-foot cost.
- Permit scope: Jobs that touch the public right-of-way or trigger a plan check carry permit and inspection fees the simpler jobs don’t.
Every estimate we write is line-item – demo, haul-away, base, rebar, pour, finish, joints – so you can see exactly what you’re paying for. Upfront pricing, no surprises: the number you see is the number you pay. None of the numbers above include decorative borders, drainage channels, or a new apron cut to accommodate a garage-door change – those get priced separately if you need them.
See the difference
Before
After
Before
After
Before
AfterWhat Santa Ana homes specifically do to this job
Santa Ana is the densest and most permit-friction-heavy city in Orange County for construction, and driveways feel that. Much of the housing stock in the older core dates from the 1920s through the 1950s – Spanish Colonial Revival, Craftsman bungalows, and post-war stucco tract homes – with shallow slabs or pier-and-beam foundations and, often, an unpermitted addition or a second slab poured over the first. When we demo a driveway in ZIP codes like 92701 or 92707, we plan for surprises underneath rather than pretending they won’t happen. The city’s plan-check culture is strict and Cal/OSHA scrutiny is real, so we pull the permits when the scope needs them and build the schedule around the inspection rather than fighting it. Santa Ana’s hot, dry Santa Ana winds in fall and winter also crack exterior stucco and stress concrete joints faster than the milder coastal-influenced climate further south, which is one reason we seal control joints as standard rather than optional. If the driveway is part of a larger project, homeowners often pair the work with ADU Site Prep & Utilities in Santa Ana – the same trenching, grading, and inspection realities apply.
Serving Santa Ana, CA – Our Local Coverage Area
We serve Santa Ana and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Santa Ana

Most jobs take 3 – 5 working days from demo to pour, then 7 days before you can park on it. The curing window is non-negotiable: concrete keeps gaining strength past day 7, and driving on it early is how you get a cracked apron six months later. Call (833) 522-5059 and we’ll give you a schedule based on your actual square footage.
If the driveway touches the public right-of-way or the work changes drainage or grade, yes – and in Santa Ana the plan-check process is stricter than in neighboring unincorporated areas. Purely interior or rear pads usually don’t need one. We tell you up front whether your job needs a permit and pull it for you if it does.
Usually, yes – concrete work is almost always a surface job. The exceptions are when a sewer clean-out, irrigation line, or gas stub sits in the pour zone, which we locate before demo. If something has to be relocated, it’s priced as a line item so you see it before we start, not after.
The range is $4,500 – $12,000 for installation, higher for full replacement with demo. Size, existing condition, finish, and permit scope are the variables that move it. Call (833) 522-5059 for an exact quote – estimates are free.
Our work is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. That’s two years on workmanship, one of the longest guarantees in residential construction. Our technicians have up to 12 years of experience, and every crew member is background-checked and arrives in uniform.
Get a free concrete estimate in Santa Ana
We’ll walk your driveway, measure the actual square footage, and hand you a written line-item estimate – demo, base, rebar, pour, finish, and any permit scope – before you commit to anything. No change orders after the pour. Call (833) 522-5059 to schedule your free estimate. Calls are answered by a live person, 24/7. If you’re weighing options, our Driveway & Pavers service and our work across Santa Ana both feed into this page – and if new doors are part of the plan, homeowners often pair this with Door Installation in Santa Ana.
Written by the team at Groundwork Construction Co.












